How to backup axis camera station server

#How to backup axis camera station server software#
#How to backup axis camera station server password#
#How to backup axis camera station server Pc#

If we were not DIY-crazy, we would have probably gone the Easy-DIY route and bought an all-in-one home security kit from Ring or Simplisafe.Д«ut we felt deep unease about these brands storing our video footage on the cloud, especially indoor videos. But we wanted to be check in on our home while we were away. We didnвЂ™t know much about home security or security cameras at that point. Recording parameters can be adjusted through Axis Camera Companion as well.A few years ago, my wife and I decided to get a CCTV security system. The site can be accessed through Axis Camera Companion to view both live video and recorded video. Here it shows a view of a cubicle wall.ДЄt this point setup should be finished and the cameras should be recording video to the TeraStation NVR unit. Since our setup only has one camera, that is all that is shown. One camera will be shown in the main section with all cameras shown across the bottom. Once the configuration is finished the Camera Companion should go to a live view of all cameras.Depending on the number of cameras this step could take several minutes. The wizard will now configure the cameras to access the share using the credentials created earlier.

#How to backup axis camera station server software#

Once the storage configuration is finished the software will display all cameras configured for this share.

Doing this manually could take 5-10 minutes or more per camera.

The Camera Companion software will now configure a user and set a quota for each camera in the site.

This is the part of the setup automated by the software.

Select the 'Recordings' share and click Next.

#How to backup axis camera station server password#

The username will be 'admin' and the password will be 'password' unless it was changed in step 6.

Enter the username and password for the TeraStation.

Click the Connect Network Share button.

If not all the cameras are detected, check to make sure that all cameras have power and are connected to the network.

The wizard should locate all attached cameras.

The first screen should tell you to make sure all your cameras are attached to the network and powered up.

Name the site and create a password for the site.

Click Get StartedВ to begin creation of a new camera site.

Note: If the system running Axis Camera Companion has internet access, you will be asked to create an account with Axis. Note: Repeat steps 8-9 for each camera that will be used in this setup.

Enter the correct IP address for the camera.

Right-click the camera and click Assign IP Address.

Once the wizard finishes you can close the browser window. We're leaving this one at the default for demonstration purposes. It is recommended that the default password be changed at this time to a more secure one. The default administrator username is 'admin' and the default password is 'password'.

Go through the initial TeraStation setup wizard.

This should launch the TeraStation GUI in the default web browser.

Right-click the icon for the TeraStation and click Settings.

Click the 'IP Address' tab and assign the correct IP address. This should launch the property sheet for the TeraStation.

Right-click the icon for the TeraStation and click Properties.

The TeraStation should show up in the interface.

#How to backup axis camera station server Pc#

Set a static IP in the desired range on the PC to be used for configuration.Connect all equipment to the switch and power it on.Gigabit Ethernet switch (PoE capable if desired).Axis cameras (TeraStation supports up to 16 cameras).Setting up Axis Camera Companion with TeraStation using static IP addresses